Clutch master cylinder, replacing

Remove brake fluid reservoir cap. Using a clean syringe, remove brake fluid from reservoir until level falls below clutch master cylinder feed pipe.
Working at pedal cluster, remove pin from clutch pedal. Remove clutch master cylinder retaining bolts and remove fluid outlet pipe.
- NOTE: Place pan under hydraulic lines to catch dripping fluid.
Lower clutch master cylinder to remove fluid inlet pipe and remove clutch master cylinder.
Installation is reverse of removal. Remember to:
- Replace O-ring on inlet pipe.
- Refill reservoir with clean DOT 4 brake fluid.
- Bleed clutch hydraulic system and check system for leaks. See Clutch hydraulic system bleeding and flushing.

Gen 1 2002-2006